Connections from the SEII to a 3rd party pulse processor are typically made through the external Scanning Interface Unit's DB-25 rear-panel connector labelled PHA Logic I/O. In certain circumstances, a direct connection to the DB-37 connector on the back of a SEII board is allowed. Shown below are the connections for the 4505 and 4530 pulse processors.

SEII DB37 SIU DB25 4505/4530 (ADC Busy) 4/22 --->> 2/15 --->> 5/6 - Start of Conversion (Pulse Reject) 5/23 <<--- 3/16 <<--- 4 - Reject (Live Time) 3/21 <<--- 4/17 <<--- 2 - DT (Fast Channel) 2/20 <<--- 6/19 <<--- 1 - C Rate (PHA Input) 6/24 <<--- BNC <<--- BNC - Output

Each signal line has its own ground reference (the pins are listed as signal/ground). The required connections for this pulse processor are shown to the above right.

Special Notes:

• The 4505 and 4530 have a special Burndy Connector labelled EDC. 4505/4530 pin numbers 1,2,4,5, and 6 are Burndy pin numbers. The 4505/4530 analog Output is on a separate rear-panel BNC connector.